Wellcraft Cruisers Owner's Manual Page 69

  • Download
  • Add to my manuals
  • Print
  • Page
    / 119
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 68
AC BREAKERS AND SWITCHES
The number and type of AC switches and break-
ers at the main electrical panel varies by model
as do the identification tags and the ratings of
the breakers. Switches and breakers are listed
below in alphabetical order.
AC panels have gauges indicating voltage of AC
power supply and amperage drawn by AC com-
ponents and accessories.
NOTE: If the transfer switch is activated, the
electrical load can exceed the capacity of a sin-
gle 30 amp power cord. Exceeding 30 amps will
cause the main service breaker to trip. If the
main breaker trips, shut off equipment to
reduce the load before resetting the main ser-
vice breaker.
HELM SWITCHES
The number and type of switches and breakers
at the helm varies by model as do the identifica-
tion tags and the ratings of the breakers.
Switches and breakers are listed below in
alphabetical order.
GALVANIC CORROSION
Corrosion of metal parts, especially those sub-
merged in salt water, is a common problem for
boat owners. Corrosion is caused by stray elec-
tric currents from shore stations supplying AC
current, improperly grounded AC lines and cir-
cuits, and poorly insulated DC–powered
equipment from boats moored nearby.
Zinc anodes have been installed either on your
boat’s sterndrives or, on inboard powered
boats, on the transom. These anodes will cor-
rode before any other submerged metal parts.
Consult your dealer for their exact location.
Whenever your boat is hauled out of the water,
have your anodes inspected and replaced if nec-
essary. Do not paint over zinc anodes. If new
anodes are installed in spring, be sure to
inspect them again in late summer, especially if
you have done a lot of cruising to other marinas.
Use only Wellcraft replacement parts. When
adding accessories not supplied by Wellcraft,
consult your dealer regarding proper selection
and installation.
6-8
Switch Function
Accessory Supplies power to any customer supplied equipment
Anchor Winch Raises or drops anchor (3–position toggle switch, defaults to off)
Aft Bilge Operates aft bilge pump
Anchor Lights Turn anchor lights on or off
Battery Parallel Allows use of both batteries
Bilge Operate bilge pump(s) manually
Blower Supplies power to bilge blowers
Cockpit Lights Turn cockpit lights on or off
Courtesy Turn courtesy lights on or off
Depth Controls power to depth finder, if so equipped
Dimmer Controls brightness of dash lights
Dock Lights Turn dock lights on or off
Engine Room Lights Turn lights in engine room on or off
Page view 68
1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 118 119

Comments to this Manuals

No comments